Enterasys Networks CSX6000 - Manual (Page 326)

USER’S GUIDE
326 CyberSWITCH
9. If IPX RIP has been enabled for the system, enter the following:
a.
RIP send control (do not respond or respond)
b. frequency (in seconds) of sending RIP updates
c. RIP receive control (do not respond or respond)
d. time (in seconds) to age RIP entries
e.
RIP respond control (do not respond or respond)
10. If IPX SAP has been enabled for the system, enter the following:
a. SAP send control (do not respond or respond)
b. frequency (in seconds) of sending SAP updates
c. SAP receive control (do not respond or respond)
d. time (in seconds) to age SAP entries
e.
SAP respond control (do not respond or respond)
11. After all the interface information has been entered, a summary screen will be displayed
similar to the sample screen below:
12. As shown above, enter “Y” to save the interface configuration.
13. Repeat this procedure to add additional interfaces.
U SING M ANAGE M ODE C OMMANDS
ipxnetif
Displays the current IPX network interface data.
ipxnetif [add/change/delete]
Allows you to add/change/delete an IPX network interface.
Current Configuration for INTERFACE "lanport1":
Interface Type LAN
IPX Network Number 11111111
MTU (bytes) 1497
Encapsulation Ethernet 802.2
LAN Port 1
RIP Configuration:
Send Control Send
Send Frequency 60 seconds
Receive Control Receive
RIP entry Ageing Time 180 seconds
Respond Control Respond
SAP Configuration:
Send Control Send
Send Frequency 60 seconds
Receive Control Receive
SAP entry Ageing Time 180 seconds
Respond Control Respond
Are you sure you want to add the INTERFACE "lanport1" (Y or N) [Y]? Y