Enterasys Networks CSX6000 - Manual (Page 387)

Central Site Remote Access Switch 387
C ONFIGURING C ALL C ONTROL
Digital Modem Inactivity Timeout
D
IGITAL
M
ODEM
I
NACTIVITY
T
IMEOUT
This feature allows the CyberSWITCH to disconnect inactive modem connections based on lack of
activity for a specified amount of time. This feature does not affect digital HDLC connections.
C ONFIGURING THE D IGITAL M ODEM I NACTIVITY T IMEOUT
U SING CFGEDIT
1. From CFGEDIT’s Options Menu, select Call Control Options.
2. Select Digital Modem Inactivity Timeout. A screen similar to the following will display:
3. Respond to the menu prompts to change the current configuration, and then enable the Modem
Inactivity Timeout feature.
4. Specify, in minutes, the amount of time the CyberSWITCH should wait to terminate
connections to inactive digital modem devices.
5. To activate the new Modem Inactivity Timeout value, you must save CFGEDIT changes, and
restart the CyberSWITCH.
U SING M ANAGE M ODE C OMMANDS
modinact
Displays the current Modem Inactivity Timeout value.
modinact [change]
Allows you to change the Modem Inactivity Timeout configuration as if you were in the
CFGEDIT screen.
Note: If this feature is changed using Manage Mode, the changes will not affect any calls
currently up or in progress. It will only affect subsequent calls.
M ODEM I NACTIVITY T IMEOUT C ONFIGURATION E LEMENTS
M ODEM I NACTIVITY T IMEOUT V ALUE
The amount of time, in minutes, the CyberSWITCH should wait before terminating connections to
digital modem devices based on a lack of data transfer. You may specify a value between 1 and 42
minutes. The default value is 0 (feature disabled).
The Modem Inactivity Timeout is currently DISABLED.
Do you wish to change the Current Modem Inactivity Timeout Configura-
tion (Y or N) [default = N]: ?
Y
Do you wish to ENABLE the Modem Inactivity Timeout (Y or N) [default
= N]: ?
Y
Modem Inactivity Timeout (1 - 42 minutes) [default = DISABLED]: ?
30