Enterasys Networks CSX6000 - Manual (Page 705)

Central Site Remote Access Switch 705
A DMINISTRATIVE C ONSOLE C OMMANDS T ABLE
modem upgrade modem# > installs new modem firmware onto specified modem
modem devices displays active modem connections
neif displays the interface table
pkt capture specifies which packets will be captured by the packet
capture feature (all, reqd, pend, actv, idle, or none)
pkt mac enables the MAC address monitor display
pkt [on/off] enables or disables the Packet Capture feature
pkt display displays captured packets
pkt load loads previously saved Packet Capture file into memory
pkt save saves captured packets to a disk file
primcsm displays message indicating whether or not CSM acting as
a Primary Service
pswd (GUEST) changes password for current access level
quit terminates system program
radius chap attempts a RADIUS authentication session using CHAP
radius iphost attempts a RADIUS authentication session using IP Host
resolution
radius ipres attempts a RADIUS authentication session using IP
resolution
radius macres attempts a RADIUS authentication session using MAC
resolution
radius pap attempts a RADIUS authentication session using PAP
restore copies backup config files into current files
restart restarts the system program remotely using Telnet
sentry ace attempts an authentication session using ACE
sentry radius attempts an authentication session using RADIUS
sentry status displays current status of user level authentication servers
sentry log logs rejection messages from the authentication server
ser stats displays current serial interface statistics for each V.35 or
RS232 line attached to card in specified slot.
ser clear clears current serial interface statistics for each V.35 or
RS232 line attached to card in specified slot.
Command
Use