Enterasys Networks CSX6000 - Manual (Page 418)

V
ERIFYING THE
B
ASE
S
YSTEM
O VERVIEW
This chapter describes the verification process for the base system. It includes the verification
process for:
• hardware resources
• WAN lines
• LAN connections
• bridge initialization
• routing initialization
• remote device connectivity
• multi-level security
• IP Host Mode
• alternate accesses
To perform the verification procedures, WAN lines must be available and ready to use. LAN
attachment components must also be available and ready to use.
During some of the procedures, we ask you to enter an administration console command. To enter
these commands, you must have an active administration session. If you need instructions for
starting an administration session, refer to
Accessing the CyberSWITCH .
Note: At least one remote device is required to proceed with many of the verification procedures.
H
ARDWARE
R
ESOURCES
O
PERATIONAL
?
WAN A DAPTER I NITIALIZED ?
1. At the system prompt, enter the dr command to display current system messages. At the
administration console type:
dr
2. For each WAN adapter installed, look for these WAN adapter initialization messages among
the system messages:
Bootstrap loaded on WAN card in slot , waiting for response
Bootstrap came alive on WAN card in slot
Downloading WAN card in slot with operational software
Waiting for WAN card in slot to complete initialization
WAN card in slot signals it is operational
If you see these WAN adapter initialization messages, then the WAN adapter in the indicated
slot is operational. You may continue with the verification of the LAN adapter.
3. If these WAN adapter initialization messages are NOT displayed, and you see one of the
following error messages, you may have a problem: