Static arp table entries, Configuring static arp table entries, Static arp table entries configuration elements – Enterasys Networks CSX6000 User Manual
Page 288: Static arp table entries background information, Static arp table entries 288, Arp t
USER’S GUIDE
288 CyberSWITCH
S
TATIC
ARP T
ABLE
E
NTRIES
C
ONFIGURING
S
TATIC
ARP T
ABLE
E
NTRIES
U
SING
CFGEDIT
Once IP has been enabled, the full IP Configuration menu will be displayed as shown below:
The advanced IP routing options, including ARP table entries, are configured through this menu.
To enter a static ARP table entry manually:
1.
Select Static ARP Table Entries from the IP menu.
2.
Select to add a Static ARP table entry.
3.
Enter the device’s IP address.
4.
Enter the device’s MAC address.
S
TATIC
ARP T
ABLE
E
NTRIES
C
ONFIGURATION
E
LEMENTS
IP A
DDRESS
The IP address for the device for which you are making an entry. Only LAN interfaces are valid.
MAC A
DDRESS
The MAC address (Ethernet address) for the device for which you are making an entry.
S
TATIC
ARP T
ABLE
E
NTRIES
B
ACKGROUND
I
NFORMATION
When sending out IP packets, ARP (Address Resolution Protocol) is used to translate IP addresses
to Ethernet addresses. As a rule, this translation is done dynamically. In rare situations, you may
need to manually enter a static ARP table entry. Maximum configuration allowed: 16 static ARP
entries. Use the
ip arp
command to display all dynamic or statically configured ARP entries.
Note:
Static ARP entries can be created only for LAN interfaces. They are not supported for WAN
RLAN interfaces.
IP Routing Menu:
1
) I
P Routing (Enable/Disable)
2) IP Operating Mode
3) IP Interfaces
4) IP Static Routes
5) RIP (Enable/Disable)
6) IP Static ARP Table Entries
7) Isolated mode (Enable/Disable)
8) Static Route Lookup via RADIUS (Enable/Disable)
9) IP Address Pool
10) DHCP Configuration
11) IP Filters
12) NBNS and DNS name server addresses
13) Security Associations
Select function from above or