Enterasys Networks CSX6000 - Manual (Page 620)

USER’S GUIDE
620 CyberSWITCH
The set escape command can be used to change the “escape” character for the current
Telnet session. This command may be useful when a device is connected to a target host,
using several different Telnet connections. By changing the escape character to a value
other than the default (), the user can return to Telnet “command” mode for a
particular session.
Typically, Telnet “escape” characters have the form ‘‘ (i.e., the CTRL key +
some other key must be pressed). The parameter for the “set escape” command
may have any of the following values:
•
, where is in the range of ASCII 'A' to ASCII '_'
• , where is in the range of ASCII 'a' to ASCII 'z' (note that lower
case letters are converted to upper case before they are used)
• , where is in the range of ASCII '!' to ASCII '~'
To specify the key in the set escape command, use the ’>’ character. The
following is an example of setting the escape character equal to ‘ P’:
status
The status command can be used to interrogate information about the current Telnet
session.
toggle
The toggle command can be used to set various operating parameters for the current
Telnet session. Currently, the only parameter available is debug .
If no parameters are specified on the toggle command line (or if toggle ? is entered),
the following help message is displayed:
The toggle debug command allows you to turn the Telnet debug mode on or off. If the
debug mode is turned on, messages beginning with “[TELNET-C]” may appear in the
system log file. Most users will not find these messages helpful. If you have difficulty with
the system Telnet client feature, we suggest you call your Distributor or Customer Support.
T ERMINAL C OMMANDS
The CyberSWITCH supports two terminal types: vt100 and ANSI. When a Telnet connection is
established, the system attempts to negotiate the terminal type. When the negotiation fails, the
system sets the terminal type to vt100.
To successfully issue the pkt display , semi perm , and mc commands, you must have the
terminal type set identically for both the Telnet emulator and the terminal emulation. To do this,
use the
term set command.
[System Name]> set escape ^P
Escape character is ‘^P’.
[System Name]> toggle
Available toggle commands:
debug - Turn TELNET debug mode on or off.
? - Display this help information.