beautypg.com

Resource background information, Resource background information 117 – Enterasys Networks CSX6000 User Manual

Page 117

background image

Central Site Remote Access Switch 117

C

ONFIGURING

R

ESOURCES

AND

L

INES

Resources

R

EGION

For NET3 and NET5 switchtypes. When configuring switches, first identify the region of operation,
and then the country.

C

OUNTRY

For the NET3 and NET5 switchtypes. The country in which the system is operating.

G

ENERIC

N

UMBER

For PRI_4ESS primary rate switch type only. The software load (generic # ) the switch is running.

S

YNCHRONIZATION

T

YPE

For Primary adapters only. Every framed transmission line requires a clock source from which it
must derive the appropriate bit timing and channel timing relative to the start of a frame. For most
CPE gear, the clocking is derived from the received signal and the transmission clock is thus a
“slave” to the network. However, if the line is to provide its own clocking, it must derive a clock
from an internal source rather than a received signal. The line is then a “master” clock source.

PCM E

NCODING

M

ETHOD

For DM-24 and DM-30 adapters only. Pulse Code Modulation (PCM) is a common method of
encoding an analog signal into a digital bit stream. PCM encoding choices are:

mu-law (the PCM encoding standard used in Japan and North America)

A-law (the PCM encoding standard used in Europe)

R

ESOURCE

B

ACKGROUND

I

NFORMATION

The basic rate (BRI) resource directly terminates a standard USOC RJ45 connector. It is supplied
with a standard S/T interface. A U interface option is not available for this adapter. The BRI
resource supports 1 or 4 connections/ports depending on which option you purchase. It provides
support for the following switch types:

NTT

5ESS

DMS100

NI1

1TR6

NET3

Definity

Legend

TS0-13

BASIC RATE NET is a test facility. This should not be configured as a resource type.

The T1-E1-PRI can be used for any T1, E1, or PRI resource, and directly terminates a standard
USOC RJ45 connector. It is supplied with a standard S/T interface and supports one port. It also
provides support for the following switch types:

NTT

4ESS

5ESS

Definity

DMS100, DMS250, DMS500

SL100

NET5

This manual is related to the following products: