Enterasys Networks CSX6000 - Manual (Page 483)

Central Site Remote Access Switch 483
S YSTEM M ESSAGES
System Message Summary
[ACCT] Warning code: Timeout
This message is logged when there is no communication with the server. Either the accounting
server is not up and running, or it cannot access the IP address. Verify the configuration of the
server.
ACE authentication is not available. You must first ENABLE ACE user level authentication.
An attempt was made to configure the Terminal Server Security for ACE and ACE was not
configured on the CyberSWITCH.
Activation Failure- Session NOT active
An error has been detected in the R2 signaling procedure, and will typically result in a failed call.
The error was due to unrecognizable or incorrect information. If problem persists, contact your
Distributor or Customer Support.
Adapter does not respond: adapter # ’x’
The WAN card initialization subsystem encountered an error on the indicated adapter. Restart the
system. If the problem persists, the indicated adapter card may be faulty and you should contact
your Distributor or Customer Support.
Adapter # ’x’ failed to initialize
The operational software on the indicated adapter card failed to signal that initialization was
completed. Restart the system. If the problem persists, the indicated adapter card may be faulty and
you should contact your Distributor or Customer Support.
Adapter # ’x’ failed to respond from bootstrap
The WAN card initialization subsystem encountered an error on the indicated adapter while
downloading the bootstrap program. Restart the system. If the problem persists, the indicated
adapter card may be faulty and you should contact your Distributor or Customer Support.
Adapter failed to respond while programming: adapter 'x'
The WAN card initialization subsystem encountered an error on the indicated adapter while
programming the hardware. Restart the system. If the problem persists, the indicated adapter card
may be faulty and you should contact your Distributor or Customer Support.
Administrative Session using ACE does not support password change.
Passwords may only be changed via the ACE Server administrator initiation. During an
administrative login, the user attempted to change password. ACE only supports password change
initiated by ACE Server administrator.
AppleTalk routing initialized successfully.
This message is posted when the system AppleTalk routing feature has initialized successfully.
AppleTalk routing RTMP initialization error, AppleTalk disabled
AppleTalk is disabled because there is an initialization problem with the Routing Table
Maintenance Protocol (RTMP). Contact your distributor or Customer Support.
AppleTalk routing ZIP initialization error, AppleTalk disabled
AppleTalk is disabled because there is an initialization problem with the Zone Information
Protocol (ZIP). Contact your distributor or Customer Support.
AppleTalk successfully initialized on LAN port with address .
This message is posted when the specified AppleTalk LAN port has initialized successfully.