Isdn usage commands, Isdn usage commands 607, Isdn u – Enterasys Networks CSX6000 User Manual
Page 607
Central Site Remote Access Switch 607
S
YSTEM
C
OMMANDS
ISDN Usage Commands
ipx route
Displays the current routing table for the system, including static and learned routes.
ipx route stats
Displays routing table statistics, including maximum number of routes configured, and
number of currently-available routes. Refer to
.
ipx service
Displays the current routes to IPX services for the system, including static and learned routes.
ipx service stats
Displays the current service table statistics, including the maximum number of services this
router is configured to handle, and the number of currently-available services. Refer to
.
ipx sap stats
Displays the IPX SAP statistics. Refer to
for definitions.
ipx spoof stats
Displays the IPX spoofing statistics. The IPX spoofing statistics displayed are self-explanatory.
ipx stats
Displays the IPX statistics. Refer to
, for a list of available statistics and
their definitions.
ipx trigreq [device]
Generates a triggered RIP/SAP update request to the specified device. You may use this
command to initiate an update request to synchronize with the routing database of a particular
WAN device.
ipx trigrip stats
Displays the triggered RIP statistics. Refer to
.
ipx trigsap stats
Displays the triggered SAP statistics. Refer to
ISDN U
SAGE
C
OMMANDS
The following commands are used to display and clear ISDN B-channel monitoring information.
isdn usage
Displays the following ISDN B-channel monitoring information:
•
The number of ISDN B-channels available.
•
The number of ISDN B-channels in use.
•
The high-water mark for the number of ISDN B-channels in use.
•
The value which the number of ISDN B-channels in use must meet or exceed in order to
cause an isdnUsageHigh SNMP trap to be generated by the system.
•
The enabled status for the generation of the ISDN usage traps (isdnUsageHigh and isd-
nUsageNormal).
•
The elapsed time since the monitoring of the high-water mark began.