Enterasys Networks CSX6000 - Manual (Page 501)

Central Site Remote Access Switch 501
S YSTEM M ESSAGES
System Message Summary
Error during channel initialization Access
An error has occurred during the initialization of the indicated Frame Relay Access, or port. Likely
cause of this entry is that the system has run out of memory. Contact your Distributor or Customer
Support.
Error during port initialization Access >
An error has occurred during the initialization of the indicated Frame Relay Access, or port. Likely
cause of this entry is that the system has run out of memory. Contact your Distributor or Customer
Support.
Error during PVC initialization Access >
An error has occurred during the initialization of the indicated. Likely cause of this entry is that the
system has run out of memory. Contact your Distributor or Customer Support.
Error initializing WAN card:
The system could not initialize the specified WAN card during system initialization. Check the
WAN card installation and configuration. If the error continues, report the problem.
Error in last LMI message detected Error >
An error was detected in the last LMI message forwarded by the network. The error is identified
by the indicated error code.
Error loading WAN board, data verify error: adapter ’x’
The WAN card initialization subsystem encountered an error during download verification. The
specified adapter card may be faulty. Contact your Distributor or Customer Support.
Error mapping WAN adapter # ’x’ into Host memory map
The configured memory location of the indicated WAN card conflicts with another WAN card or
device. Review the configuration for the indicated adapter.
Error opening file
Error opening file , section =
Error parsing old WAN (Direct Host) interface: bad format
The information contained in the WAN (Direct Host) interface is invalid. To correct, use CFGEDIT
to reconfigure the interface.
Error initializing WAN card:
The system could not initialize the specified WAN card during system initialization. Check the
WAN card installation and configuration. If the error continues, report the problem.
Error parsing old WAN (Direct Host) interface: LAN interface for specified port
already in use
This error may display after upgrading software which contains secondary IP addressing and an
“old” style WAN (Direct Host) interface. To correct, use CFGEDIT to delete any WAN (Direct Host)
interfaces on the problematic LAN port, and reconfigure them.
Error parsing old WAN (Direct Host) interface: no LAN interface for specified port
This error may display after upgrading software which contains secondary IP addressing and an
“old” style WAN (Direct Host) interface. To correct, use CFGEDIT to delete the problematic WAN