Enterasys Networks CSX6000 - Manual (Page 506)

USER’S GUIDE
506 CyberSWITCH
File Access Err
System unable to access file. Check for one of the following log error messages:
Error opening file
Error reading file , section =
Error opening file , slot
Read 0 bytes from file for WAN card in slot
Failure during read of file for WAN card in slot
Error closing file , slot
Error closing password data file
Error opening password data file
Failure on closure of file
Failure opening file
Failure on file closure
Failure on write of file
If you see any of these log messages repeatedly, there may be a problem with the file system.
Contact your Distributor or Customer Support.
Formatting Flash Memory.....
The user has either requested the Flash to be formatted or a corrupted Flash File System was
detected while attempting to save an upgrade/installation file set (transferred via X-Modem).
[FR_IETF] Authentication Failure of remote device NAME
[FR_IETF] Off-Node Authentication Failure of remote device NAME
The device database does not contain an entry for the device specified by NAME. Reconfigure
either the PVC name or the device name so that they match.
[FR_IETF] detected PPP protocol from "NAME", shutting down PVC
FR_IETF has detected a configuration mismatch between the system and the remote device NAME.
The administrator must change the PVC configuration on one of the devices.
Frame Relay event queue full
Indicates a lack of system resources to handle the level of traffic being experienced. Contact your
Distributor or Customer Support.
Frame Relay PVC connection down: Slot=, Port=
The Frame Relay PVC connection is down for the indicated slot and port number.
Frame Relay PVC connection up: Slot=, Port=, DLCI=
The Frame Relay PVC connection is up for the indicated slot, port, and DLCI index.
FrBufFree: error during free
The indicated error occurred during an attempt to free a buffer to its memory pool. Contact your
Distributor or Customer Support.
FrUtl: No registered device for DLCI
A frame was received on the PVC associated with the indicated DLCI, and no Frame Relay Service
Device had (as yet) registered to use this PVC.