AJA FS2 - Manual (Page 76)

76
SYSTEM Menu Group
1 Component In
Format This parameter configures the format of the Component video input for SMPTE,
Beta, or Composite. Selecting Composite (Y) programs the Component (Y/G) input to
accept a composite signal. In this case, all parameters set to a value of Component
are subject to and influenced by the composite signal on the Component Y/G input.
For example, in the VIDEO menu, setting Video1 Input to the value of Component,
switches the composite signal on the Component Y/G input into the Video 1
Processor.
2 Component
Out Format This parameter configures the format of the Component video output for SMPTE,
Beta, RGB, or Composite. Selecting Composite (Y) programs the Component (Y/G)
output to deliver a composite signal. In this case, all parameters set to a value of
Component are subject to and influenced by the composite signal on the Y/G
Component output. For example, in the OUTPUT menu, Component Out, selecting
Processor2 will switch the composite signal from Video Processor 2 to the
Component Y/G connector.
3 Analog Audio
Std This parameter sets the Analog Audio Input and Output levels of the FS2 with
reference to full scale digital (0 dBFS). Selections range from consumer levels (+12
dBu) to SMPTE professional (+24 dBu).
Note: See Chapter 3 FS2 Audio Level Choices—Pro or Consumer regarding audio levels.
1 Cmpnt In Format Selections Selection Descriptions
SMPTE YPbPr (default)
Beta YPbPr
Composite (Y)
Configure the Component Video Input source as SMPTE YPbPr. This is
the default for HD component video.
Configure the Component Video Input source as Beta YPbPr (standard
definition).
Configure the Component Video Input source as composite, providing a
second composite input (requires version 1.1 firmware).
2 Cmpnt Out Format Selections Selection Descriptions
SMPTE YPbPr (default)
Beta YPbPr
RGB
Composite (Y)
Configure the Component Video Output as SMPTE YPbPr. This is the
default for HD component video.
Configure the Component Video Output as Beta YPbPr (SD).
Configure the Component Video Output as RGB.
Configure the Component Video Output source as composite, providing
a second composite output (requires version 1.1 firmware).
3 Analog Audio Std Description of Choices
+24 dBu (default)
+18 dBu
+15 dBu
+12 dBu
Select +24 dBu as the expected analog audio level.
Select +18 dBu as the expected analog audio level.
Select +15 dBu as the expected analog audio level.
Select +12 dBu as the expected analog audio level.
(Above settings correspond to maximum amplitude–0 dBFS)