AJA FS2 - Manual (Page 57)

1
57 FS2 Installation and Operation Manual — Controlling the FS2 via Front Panel
Menu Group
Buttons As explained in Chapter 2, you enter a Menu Group whenever you push one of the ten
Menu Group pushbuttons: STATUS, CONFIG, SYSTEM, VIDEO 1, VIDEO 2, REMOTE,
REG, OUTPUT, AUDIO 1, and AUDIO 2. When you push a Menu Group button, the
display changes to the selected menu group and shows the last viewed parameter
menu.
Holding down any button enables coarse adjustment of the current parameter using
the ADJUST knob.
SELECT and
ADJUST Knobs The SELECT and ADJUST knobs operate as follows:
• Scroll menus—Turn SELECT to scroll menus within the selected Menu Group.
• Edit a menu—Stop SELECT on a menu to select it for editing. If multiple values
may be edited, such as an IP address, push ADJUST momentarily and then turn
the SELECT knob to scroll through the values and select one for editing. The
value blinks to indicate it is the one selected.
• Change a value—Turn ADJUST to change a value, number, or letter. Turning
ADJUST forward (clockwise) or backward (counterclockwise) changes the value
up or down, respectively. When you reach the end of the available values, the
list starts over again at the beginning.
• Make a coarse adjustment—Holding down a Menu Group button enables
coarse adjustment using ADJUST for wide-ranging values.
• Undo a change—Push SELECT during value editing to abort the edit and restore
a value to its previous setting, if it has not already been saved.
• Set factory default value—Push and hold ADJUST for 4 seconds to set the
parameter to its factory default value.
• Save changes—Parameter value changes are saved within a few seconds. For
multiple values, such as IP addresses, push ADJUST momentarily (less than 4
seconds) to save or take parameter changes.
The remainder of this chapter presents menu examples followed by complete
descriptions of the Menu Groups and Parameter Menus.