AJA FS2 - Manual (Page 39)

1
1
Chapter 3:
Installation & Configuration
3
Installation Overview
The installation and set up of an FS2 is very simple. Plug both AC supply cords
into AC mains power (separate branch circuits for redundancy), connect the
LAN connector to a LAN, WAN or local computer with a web-browser, and then
connect source and destination video and audio equipment.
Hazard Warning!
High Voltage. This situation or condition can cause injury due to electric shock.
Warning!
Do not open the chassis. There are no user-serviceable parts inside. Opening the
chassis will void the warranty unless performed by an AJA service center or licensed
facility.
Warning!
Disconnect the external AC power supply line cord(s) from the mains power before
moving the unit.
Warning!
Do not defeat the safety purpose of the polarized or grounding-type plug. A
polarized plug has two blades with one wider than the other. A grounding type
plug has two blades and a third grounding prong. The wide blade or the third
prong are provided for your safety. If the provided plug does not fit into your outlet,
consult an electrician for replacement of the obsolete outlet.
Warning!
Since the Mains plug is used as the disconnection for the device, it
must remain readily accessible and operable.
Warning!
Protect the power cord from being walked on or pinched
particularly at plugs, convenience receptacles, and the point
where they exit from the device.