AJA FS2 User Manual
Page 190
192
Parameters 4.2 and 4.4 determine the SNMP Port(s) used for sending the trap
messages. UDP Port 162 is the default used for SNMP trap messages. However, if this
port is being used by another protocol or service, you can change the setting by
modifying these parameters.
4.1 SNMP Trap Dest 1
Selections
Selection Descriptions
Variable
Set the desired IP address where traps will be sent (usually a client on your
LAN). Press and turn the ADJUST knob to change the blinking values.
Use the SELECT knob to advance through the values. Press ADJUST to
save, or press SELECT to revert to previous, or hold down ADJUST to
restore the factory default setting.
Default: 192.168.0.3
4.3 SNMP Trap Dest 2
Selections
Selection Descriptions
Variable
Set the desired IP address where traps will be sent (usually a client on
your LAN). Press and turn the ADJUST knob to change the blinking
values. Use the SELECT knob to advance through the values. Press
ADJUST to save, or press SELECT to revert to previous, or hold down
ADJUST to restore the factory default setting.
Default: 192.168.0.3
4.2 SNMP Trap Port 1
Selections
Selection Descriptions
Parameter
Adjustments:
variab
Variable
Use the ADJUST knob to select a UDP port for sending FS2 trap messages.
Press SELECT to revert to previous, or hold down ADJUST to restore the
factory default setting.
Default: 162
4.4 SNMP Trap Port 2
Selections
Selection Descriptions
Parameter
Adjustments:
variab
Variable
Use the ADJUST knob to select a UDP port for sending FS2 trap messages.
Press SELECT to revert to previous, or hold down ADJUST to restore the
factory default setting.
Default: 162