AJA FS2 - Manual (Page 181)

1
183 FS2 Installation and Operation Manual — Audio 1 and 2 Screens
Audio Output
Phase Audio Output Phase enables or disables individual audio phase adjustment of the 16
audio output channels.
Note: If parameter 3 Audio Follow Video is set to On, the Audio Output Phase
selection is independently kept for each video input. If Audio Follow Video is set to
Off, a single Audio Output Phase value applies, regardless of the video input. (This
value is independent of any of the values used in Audio-Follow-Video mode.)
Audio Phase
Ch1–16 These settings select whether audio phase is normal (same as passed from the input)
or inverted on Channels 1–16.
Note: If parameter Audio Follow Video is set to On, the Audio Output Phase
selection is independently kept for each video input. If Audio Follow Video is set to
Off, a single Audio Phase value applies, regardless of the video input. (This value is
independent of any of the values used in Audio-Follow-Video mode.)
(8.0) Audio Output Phase Selections Selection Descriptions
Unity (default)
Adjust
Disable audio phase adjustments and set phase to unity.
Enable audio phase adjustments for the 16 audio channels.
(8.1-16) Audio Phase
Ch1–Ch16
Selections Selection Descriptions
Normal (default)
Invert
Phase is unaltered as it passes from the input to the output.
Phase is inverted as it passes from the input to output. (This may be useful
to correct analog audio signals that are incorrectly wired, placing audio
out of phase at input.)