AJA FS2 - Manual (Page 127)

1
129 FS2 Installation and Operation Manual — Network Pane and Network
Netmask Netmask determines the subnet mask used by the FS2 for TCP/IP networking.
(Networking is discussed in Chapter 3, “Network Connection.) Consult your network
administrator about how to set this value.
The note about editing IP addresses in parameter 2.2 also applies to 2.3 and 2.4.
Default Gateway Default Gateway determines the gateway or router used on your LAN for TCP/IP
networking. (Networking is discussed in Chapter 3, Network Connection.) Consult your
network administrator about how to set this value.
Without a properly configured default gateway (whether you have a router/gateway
or not), the FS2 will be unable to see other FS2s on the network, although you may
still be able to control this FS2 via a web browser. Also, without a proper gateway
defined, the discovery feature “Available FS2s—Click to Refresh” on the Network web
page will not work correctly and list other FS2s on the network.
(2.3) Subnet Mask Selections Selection Descriptions
Variable Enter a subnet mask compatible with your LAN. This is only needed for
Static IP configurations. The factory default Subnet Mask is 255.0.0.0
If IP Address Type is set to DHCP, the Subnet Mask is set by the DHCP
server and cannot be changed by the user.
(2.4) Default Gateway Selections Selection Descriptions
Variable Enter a default gateway or router address. This is only needed for Static
IP configurations. The factory Default Gateway is 192.168.0.1.
If IP Address Type is set to DHCP, the Default Gateway is set by the DHCP
server and cannot be changed by the user.