AJA FS2 - Manual (Page 180)

182
Audio Delay
Ch1/2-15/16
(Stereo Map)
These settings apply only when the audio input (parameter 1) is set to Stereo Map
and allows you to adjust the stereo audio delay to compensate for video timing
(delay/latency). Turning the ADJUST knob changes the delay from -16 to +256 mS or
-768 to +12288 (the default is zero delay).
If parameter Audio Follow Video is set to On, the Audio Delay selection is
independently kept for each video input. If Audio Follow Video is set to Off, a single
Audio Delay value applies, regardless of the video input. (This value is independent
of any of the values used in Audio-Follow-Video mode.)
Audio Output
Levels Audio Output Levels enables or disables individual audio output level adjustment of
the 16 audio output channels.
d
Note: If Audio Follow Video is set to On, the Audio Output Levels selection is
independently kept for each video input. If Audio Follow Video is set to Off, a single
Audio Output Levels value applies, regardless of the video input. (This value is
independent of any of the values used in Audio-Follow-Video mode.)
Audio Level
Ch1–16 These 16 settings adjust the audio levels of the 16 audio channels ± 18dB dB.
(6.17-24) Audio Delay
Stereo Map
Selections Selection Descriptions
Variable Adjustment range increments from -16 to +256 mS or -768 samples
to +12288 samples.
Default=0 (synchronized to video output).
(7.0) Audio Output Levels Selections Selection Descriptions
Unity (default)
Adjust
Disable audio output level adjustments and set levels to unity.
Enable audio output level adjustments for the 16 audio channels.
(7.1–7.16)
Audio Level Ch1–16
Selections Selection Descriptions
Variable Adjustment of audio level ±18dB range in steps of .5dB.
Default: +0dB