AJA FS2 - Manual (Page 142)

144
SNMP Trap
Destination 2 This parameter determines the secondary SNMP Trap Destination IP address where
trap messages issued by the FS2 will be sent (if desired). This parameter is available
only if parameter 4.0 SNMP Enable is set to On.
Note: Set the IP address octets (numbers between periods) as follows:
Push ADJUST momentarily to enter edit mode.
Turn SELECT to select the octet you want to edit, indicated by blinking.
Turn ADJUST to enter the new value.
Push ADJUST momentarily to save and activate the new setting.
If you need to revert to the previous setting (undo changes), push SELECT. If you
want to revert to the default value, hold down ADJUST for 4 seconds.
SNMP Trap
Port 2 This parameter determines the SNMP Trap Port used for sending destination #2 trap
messages. UDP Port 162 is the default used for SNMP trap messages. However, if this
port is being used by another protocol or service, you can change the setting by
modifying this parameter. This parameter is available only if parameter 4.0 SNMP
Enable is set to On.
Hidden Menus This selection lets you choose whether to hide or show inactive menus.
(4.3) SNMP Trap Dest 2 Selections Selection Descriptions
Variable Set the desired IP address where traps will be sent (usually a client on
your LAN). (See the note in 4.2 for instructions.)
Default: 192.168.0.3
(8) Hidden Menus Selections Selection Descriptions
Show All
Hide Inactive
Shows all menus, even those that are not in use.
Hides menus that are not in use.
Default: Hide Inactive