Rockwell Automation 20G PowerFlex 750-Series AC Drives - Manual (Page 114)

114 Rockwell Automation Publication 750-RM002B-EN-P - September 2013
Chapter 2 Feedback and I/O
Analog Output Configuration
Parameters 75 and 85 [Anlg Out
n Select] are use to specify the signal used on
Analog Outputs 1 and 2, respectively. These parameters can be programmed to
the following selections.
Scaling
The scaling for the analog output is defined by entering analog output voltages
into two parameters, P91 [Anlg Out1 Lo] and P90 [Anlg Out1 Hi]. These two
output voltages correspond to the bottom and top of the possible range covered
by the quantity being output. Scaling of the analog outputs is accomplished with
low and high analog parameter settings that are associated with fixed ranges (see
the PowerFlex 750-Series Programming Manual, publication
750-PM001 ,) for
each target function. Additionally, the PowerFlex 755 contains an adjustable scale
factor to override the fixed target range. P77 [Anlg Out0 Data] and 82 [Anlg
Out0 Val] are described in the following charts.
Parameter No. Parameter Name
1 Output Frequency
2 Commanded SpdRef
3 Mtr Vel Fdbk
4 Commanded Trq
5 Torque Cur Fdbk
6 Flux Cur Fdbk
7 Output Current
8 Output Voltage
9 Output Power
11 DC Bus Volts