System information, Dialout settings, Call reception settings – Sensaphone SCADA 3000 Users manual User Manual
Page 35
2-3
Chapter 2: Quick Start Guide
Figure 5. Main Programming form
Select the Programming pull-down menu.
Choose “System” to bring up the system form.
Figure 6: System form
System Information
Both the Unit Name and ID Number should be the same as those you assigned on the New
Unit form.
Dialout Settings
1. Dial Method: Can be either tone or pulse. Default setting is Tone.
2. Dialing Prefix: for E-Mail prefixes only. If you need to dial a “9” to get an out
side line before dialing an email server number, enter that here. For other dialout
prefixes see the “Destinations” section of the manual.
3. Voice repetitions: The number of times the SCADA 3000 repeats alarm messages
per call. Default setting is 2.
4. Maximum calling rounds: the number of times a SCADA 3000 will dial through
your list of destinations to deliver its messages. Default is 100.
5. Alphanumeric Pager Speed: Default setting is 1200 Baud
Call Reception Settings
1. Rings till Answer: the number of times the SCADA will let the phone ring before
answering an incoming call. Default is 1 ring; range is 1-20 rings.
2. Carrier Wait Time: The amount of time SCADA will wait for a modem
connection when receiving an incoming call. Default is 60 seconds; range is 0 to
90 seconds.
Note: Don’t set this time too short, or a modem connection may never be established.