Sensaphone SCADA 3000 Users manual - Manual (Page 217)

19-3
Chapter 19: Internet Web Status
Figure 3: Global Web Status Tab
Check the “Deliver to FTP host” box to enable the delivery settings. The host address should
be the ISP address of your site.
Retries is the number of times the software will attempt to upload new page data.
Remote Dir is the folder or directory within your site where the web page is to be placed.
.wml: Check the .wml box if you would like web pages created in wml format in addition to the
HTML format. The wml format is specifically for use with internet-capable cell phones.
Username and Password are those needed to access and make changes via FTP to your site.
In addition to FTP programming, the screen also allows you to set default logos for your web
page. The default settings shown above provide a Sensaphone logo graphic at the top of the
page and a Sensaphone banner graphic at the bottom. The bottom graphic will link to www.
sensaphone.com. A Logo or picture file (JPEG, GIF, PNG) of your choice can be selected to
appear at the top and bottom of your web page rather than the default graphics. You can also
set up the logos to link to web pages of your choice.
The settings here will operate as the global default settings for all of your SCADA 3000 units.
The chosen host and directory are where all web status reports will appear. The file name of
the web page will be based on the SCADA 3000 unit name, such as “0_ChestnutStreetPlant.
html”; however, this can be customized to your preference. Note that the default settings can
be overridden on a per-unit basis, making it possible to upload web pages for individual units to
different web servers. (See “Web Status Options”.)
Selecting Data Points for Web Status Polling
Go online with the SCADA 3000 unit that you want to configure for web status polling. On
the Main Programming Form, select Status, then Web Status Report to bring up the Web Status
form. Click on the UAFs tab.