Placing rotating elements on the palette, Placing rotating elements on the palette -19 – Sensaphone SCADA 3000 Users manual User Manual
Page 143
14-19
Chapter 14: Real-Time Screen Design
Pitch: Can be set to one of three values: fpDefault, fpFixed, or fpVariable. Using
fpDefault as the pitch value will cause the default pitch style to be used with the
font. The fpFixed and fpVariable values can be used to explicitly set the pitch; a
value of fpFixed causes each character in the font to have the same width (mono-
spacing), while a value of fpVariable allows different characters within a font to
have unique widths.
Size: Sets the point size of a font object. If you need to ensure that the font fits
within a specified area, you can manipulate the Height and Pitch properties.
Style: Sets the default style of the font or text.
fsBold: Sets the default to boldface.
fsItalic: Sets the default to italic.
fsStrikeout: Forces a line through the font.
fsUnderline: Underlines the text as default.
Height: Vertical size in pixels (overridden if you chose a Max/Min Height).
Hint: Type in the text that will appear upon mouseover.
Left: Sets the position of the component as measured from the left side of the pal-
ette.
Off Color: Color of the component in the “off” state. Default color is Red.
On Color: Color of the component in the “on” state. Default color is Green.
Show Hint: Enables the hint message to display on mouseover.
State: Checkbox. This is the On/Off, Enabled/Disabled Datapoint state.
Status Off: Message showing if status is off. Default is (Open).
Status On: Message showing if the status is on. Default is (Closed).
Status Text: Checkbox. Check if you want the status text to display.
Stay On Top: Checkbox. Check if you want the component to float above any other
graphics.
Title: Description of the component.
Visible: Checkbox. Check to make component visible.
Width: Horizontal size in pixels (overridden by Max/Min Width values, if any.)
PLACING ROTATING eLemeNTS ON THe PALeTTe
There are four components on the Rotate Tab: Rotating Blower, Rotating Pump, Rotating
Compressor, Rotating Turbine.
Figure 21. Rotate Tab