Sensaphone SCADA 3000 Users manual - Manual (Page 226)

21-2
SCADA 3000 User’s Manual
Click File, then Setup to bring up the software setup screen. (See figure below)
Figure 3: PC Dial Server Setup
In the Parameters section, select the Com Port where your modem is installed. Set
the maximum Baud rate supported by your modem (typically 115,200).
Connect Timeout: This is the amount of time (in seconds) allowed for a connec-
tion to be established. The timer starts when the number is dialed. (default = 60
seconds)
Disconnect Timeout: This is the maximum amount of time (in seconds) permit-
ted for message delivery to take place after a connection has been established.
(default = 60 seconds)
Modem Commands and Modem Messages
Do not change. These settings are configured to work with the Diamond Supramax
Express Speakerphone modem. The ability to alter these settings is provided for
cases where a different modem is being used. Contact Sensaphone Technical sup-
port for more information.
Email Settings
The PC Alarm Dialout program can send alarm messages to any e-mail address if
your computer has internet access. The program supports two methods of access-
ing the internet: RAS Dialup, or Local Always-On LAN connection (DSL, T1,
Cable modem, etc.). Enter the following information:
Host: Enter the name of the SMTP server used by your Internet Service
Provider (ISP).
UserID: Enter your e-mail account user ID as provided by your ISP.
FromAddr: Enter your e-mail address.
Connect T
ype: Select your method of accessing the internet by clicking on the
dropdown arrow. Choose either RAS (dialup) or Local (always-on).
• RAS Dialup: If you connect to the internet using a dial-up modem, then
select “Dialup (RAS)” from the Type menu. Select the service provider you
want to use from the PhoneEntry pulldown menu. Most users will only have
one service provider set up through Microsoft Dialup Networking (MDN),
and so will only have one choice in the pulldown menu.