Sensaphone SCADA 3000 Users manual - Manual (Page 121)

13-3
Chapter 13: LCD & Keypad Programming
the display, simply press the arrows until the message DISPLAY FROZEN is shown. Do not
press ENTER. The display will stay on this screen as long as the message DISPLAY FROZEN
is shown. To return to the main menu, press the MENU key several times until it is shown.
Using the Keypad
The keypad consists of four buttons labeled from left to right “UP,” “DOWN,” “MENU,” and
“ENTER.” To navigate the SCADA program, you press MENU for the main choices listed
above, and then use the ENTER and UP and DOWN keys to navigate through each program
option in the main menu and all embedded menus. When the cursor > is at the item you want,
press ENTER. The options operate as follows.
DATA POINTS
Press MENU to see the list. The cursor > will appear automatically to the left of the first item
in the list, DATA POINTS. Press ENTER to view the options for Data Points. You will then
see the following list of options: INPUTS, OUTPUTS, TIMERS, COUNTERS, BITS,
LADDER VARIABLES, C PROGRAM VARIABLE, and DIAGNOSTICS.
Inputs
Press ENTER for the first selection under Data Points, Inputs. Then use the arrow keys to
navigate up and down the list of inputs, to see those below the number displayed on the screen.
These are numbered as MODULE ADDRESS 0 through MODULE ADDRESS 15. Scroll
down or up and press ENTER for any of these to display the INPUT CHANNEL list. Scroll
through this list and press ENTER for any Channel to view its current value or to execute the
Add, Remove or Freeze functions. For each, using the arrow keys, you can scroll through 3
menu choices: ADD TO DISPLAY, REMOVE FROM DISPLAY, or DISPLAY FROZEN.
The names for the channels are customizable with your software.
Outputs
Use the DOWN arrow and ENTER to select the Outputs display. The list goes from
MODULE ADDRESS 0 to MODULE ADLESS 15. Scroll down or up and press ENTER
for any of these to display the OUTPUT CHANNEL list, 0–7. Scroll through this list and
press ENTER for any Channel to view its current value or to execute the Add, Remove or
Freeze functions. For each, using the arrow keys, you can scroll through 3 menu choices: ADD
TO DISPLAY, REMOVE FROM DISPLAY, or DISPLAY FROZEN. The Outputs are like-
wise customizable to display the identifier of your choice.
Timers
The third option under Data Points is Timers. The choices are TIMER NUMBER 0–63. Use
the down arrow to scroll through the timers below those displayed. Press ENTER for any of
the timers to bring up the TIMER PARAMETER feature. There are five parameter choices,
selected by using the arrow and ENTER keys. Press ENTER for any of parameter to view the
current value or to execute the Add, Remove or Freeze functions. For each address, using the
arrow keys, you can scroll through 3 menu choices: ADD TO DISPLAY, REMOVE FROM
DISPLAY, or DISPLAY FROZEN.
Counters
The fourth option under Data Points is Counters. The choices are COUNTER NUMBER
0–63. Use the down arrow to scroll through the counters. Pressing ENTER on any will bring
up a COUNTER PARAMETER list. Select any of the seven parameters by pressing ENTER;
this will display the current value or to execute the Add, Remove or Freeze functions. For
each, using the arrow keys, you can scroll through 3 menu choices: ADD TO DISPLAY,
REMOVE FROM DISPLAY, or DISPLAY FROZEN.