Sensaphone SCADA 3000 Users manual - Manual (Page 142)

14-18
SCADA 3000 User’s Manual
Figure 20: Electrical Tab
Properties
Align: To align graphic/component to edges of the palette area.
alBottom: Stretches the component across the bottom of the palette.
alClient: Fills the palette with the component. Useful for adding a background
graphic.
alLeft: Stretches the component along the left edge of the palette.
alNone: No realignment is applied. Note: this will not correct any other previ-
ously applied alignment.
alRight: Stretches the component along the right edge of the palette.
alTop: Stretches the component across the top of the palette.
Anchors: Sets one or more sides of the component as a positional anchor with
respect to the edges of the palette.
akBottom: Anchors the component a fixed distance from the bottom of the palette.
akLeft: Anchors the component a fixed distance from the left side of the palette.
akRight: Anchors the component a fixed distance from the right side of the pal-
ette.
akTop: Anchors the component a fixed distance from the top of the palette.
BackGndMode: bmOpaque or bmTransparent.
Color: Background color, visible only if you choose bmOpaque above.
Constraints: Limits the maximum and minimum size of the element on the palette.
MaxHeight: Sets the maximum height. (0 disables this property)
MaxWidth: Sets the maximum width. (0 disables this property)
MinHeight: Sets the minimum height. (0 disables this property)
MinWidth: Sets the minimum width. (0 disables this property)
Datapoint: Assigns the component to an I/O point within a SCADA unit.
Datapoint: Enter the datapoint UAF or click in the Datapoint box above and then
click the button at the end of the box to display the Datapoint selection form.
SCADA: Select the SCADA unit from which the datapoint information is coming.
Font: Sets the default font for labels and text. Click in the font box, then click the
small button at the end of the box to select a font.
Charset: Specifies the character set of the font.
Color: Sets the color of the text.
Height: Sets the height of the font object in pixels. If you wish to use a specific
point size, you should set the size property.