Lenze E82xVxxxKxxxxx - Manual (Page 89)

Mechanical installation
Standard devices with a power of 55 kW
Mounting with fixing brackets (standard)
5
l
89 EDS82EV903−3.0
5.6 Standard devices with a power of 55 kW
5.6.1 Mounting with fixing brackets (standard)
Mounting material required from the scope of supply:
Description Use Quantity
Fixing bracket Drive controller fixing 4
Hexagon head cap screw M8 × 16 mm
(DIN 933) Mounting of fixing bracket to the drive controller 4
Washer Æ 8.4 mm (DIN 125) For hexagon head cap screw 4
Spring washer Æ 8 mm (DIN 127) For hexagon head cap screw 4
Controller variant "2xx" (without fully assembled footprint filter)
For this mounting variant you require controller type E82EVxxxK4B2xx.
)
Note!
Before assembling the controller, please read the documentation for the
components connected on the supply side (mains choke, filter).
a
c1
e
b1
d
d1
b
l
c
³ 50 mm ³ 50 mm
g
m
k
0
³ 100 mm
³ 100mm
9300vec175
Fig. 5−23 Standard mounting with fixing brackets 55 kW
 Loosen both screws to be able to remove the housing cover. The assembly kit is located under
the housing cover.
‚ Installation of mounting angles
ƒ Dimensions
0
Arrange the controllers side by side with spacing to be able to disassemble the eyebolts.
Dimensions [mm]
8200 vector a b b1 c c1 d d1 e 1) g k m
E82EV553K4B2xx 340 672 591 28.5 283 615 38 285 11 28 18
1) If the function module is attached: observe mounting clearance and cable bending radius. The terminals of function
modules in PT design protrude above the housing by 8 mm.