Lenze E82xVxxxKxxxxx - Manual (Page 247)

Parameter setting
Parameter setting with the XT EMZ9371BC keypad
Menu structure
9
l
247 EDS82EV903 EN 3.0
Description Submenus Main menu Description
Display No. Display No.
5.8 OpenLoopV/f 3 Frequency setpoint via AIF process data channel (AIF−IN.W1)
5.8.1 Freq setpt Frequency setpoint configuration
5.8.2 f limit/ramp Output frequency, acceleration time and deceleration time
configuration
5.8.3 Motor param Motor current control configuration, motor monitoring
5.9 OpenLoopV/f 5 Operation with the system bus (CAN) function module on FIF
Frequency setpoint via process data channel (CAN−IN1.W2)
5.9.1 CAN managem System bus (CAN) communication set−up
5.9.2 Freq setpt Frequency setpoint configuration
5.9.3 f limit/ramp Output frequency, acceleration time and deceleration time
configuration
5.9.4 Motor param Motor current control configuration, motor monitoring
5.10 OpenLoopV/f 7 Operation with fieldbus function module on FIF (DRIVECOM
control)
Frequency setpoint via process data channel
5.10.1 FIF managem Fieldbus communication set−up
5.10.2 Freq setpt Frequency setpoint configuration
5.10.3 f limit/ramp Output frequency, acceleration time and deceleration time
configuration
5.10.4 Motor param Motor current control configuration, motor monitoring
Open−loop speed control in the "Vector control" operating mode
5.11 Vector−Ctrl 0 Analog frequency setpoint via analog input 1 (AIN1)
5.11.1 Freq setpt Frequency setpoint configuration
5.11.2 f limit/ramp Output frequency, acceleration time and deceleration time
configuration
5.11.3 Motor param Motor current control configuration, motor monitoring
5.11.4 Motor ident Identifying motor parameters
5.12 Vector−Ctrl 1 Frequency setpoint via parameter channel (C0046)
5.12.1 Freq setpt Frequency setpoint configuration
5.12.2 f limit/ramp Output frequency, acceleration time and deceleration time
configuration
5.12.3 Motor param Motor current control configuration, motor monitoring
5.12.4 Motor ident Identifying motor parameters
5.13 Vector−Ctrl 3 Frequency setpoint via AIF process data channel (AIF−IN.W1)
5.13.1 Freq setpt Frequency setpoint configuration
5.13.2 f limit/ramp Output frequency, acceleration time and deceleration time
configuration
5.13.3 Motor param Motor current control configuration, motor monitoring
5.13.4 Motor ident Identifying motor parameters
5.14 Vector−Ctrl 5 Operation with the system bus (CAN) function module on FIF
Frequency setpoint via process data channel (CAN−IN1.W2)
5.14.1 CAN managem System bus (CAN) communication set−up
5.14.2 Freq setpt Frequency setpoint configuration
5.14.3 f limit/ramp Output frequency, acceleration time and deceleration time
configuration
5.14.4 Motor param Motor current control configuration, motor monitoring
5.14.5 Motor ident Identifying motor parameters