Ag Leader GeoSteer Operation Manual - Manual (Page 99)

Manage Settings
Operator’s Manual 85
Reset Factory Default
Figure 3-15 Reset Factory Default
There may be occasions when it is necessary to restore a GeoSteer system back to the Factory Default settings. This could be
necessary if the system is transferred to a new owner, or the database becomes corrupted on the unit. If this becomes necessary,
the user can simply use the Reset Factory Default feature. There is only one choice in the Reset Factory Default section.
• Reset – Pressing this button will return the GeoSteer system back to factory default settings.
Note: Resetting the system to factory default will erase all current settings including vehicle profiles, Base Stations, and
NTRIP configuration profiles. Feature Codes are not affected by this process. It is strongly suggested to backup the database
using the procedure provided on Page 82 prior to resetting to factory default settings.
Reset
1. From the System tab, press the Manage Settings button, highlight Reset Factory Default from the list on the left, and
then press the Reset button.
2. Press the Green Check button to start the database reset. Press the Red X button to cancel the reset.
Figure 3-16 Database Reset Warning