Ag Leader GeoSteer Operation Manual - Manual (Page 121)

WAAS/EGNOS
Operator’s Manual 107
PRN
Figure 4-20 WAAS/EGNOS Setup
The PRN screen provides information about the WAAS/EGNOS satellites that are to be tracked. The GeoSteer system can
simultaneously track two separate WAAS/EGNOS PRNs. If the Primary PRN becomes unavailable, the system will
automatically switch to the Secondary PRN. The PRN screen provides the following information:
• Primary PRN – This is the PRN that is tracked first.
• Alternative PRN – This is the PRN that is tracked if the Primary PRN is lost.
Note: Refer to the WAAS or EGNOS websites to determine satellite availability and health for your location.
Change Primary
To set the Primary PRN follow, the instructions below:
1. From the GPS screen, press the WAAS or EGNOS button and then select PRN from the list on the right.
2. Press the Change Primary button.
3. Use the keypad to enter the Primary PRN number.
4. After the channel has been set press the Green Check button to save the setting or press the Red X button to cancel.
Note: PRNs are satellite identifiers. Refer to the WAAS or EGNOS web sites for the PRNs that are available at your location.
Figure 4-21 Change Primary PRN