Ag Leader GeoSteer Operation Manual - Manual (Page 101)

Technician
Operator’s Manual 87
Enable (Disable)
To Enable or Disable the Remote Switch, follow the instructions below:
1. From the System tab, press the Accessories button, highlight Remote Switch from the list on the left, and then press the
Enable (Disable) button.
2. Once the Enable (Disable) button has been pressed, the button will change to the opposite of what it was and the Current
Status will be updated.
Figure 3-19 Remote Switch Enabled
Technician
The Technician screen is password protected. Entry past this screen requires proper training and is only to be used by qualified
service technicians. There are no normal operation options required by users in this screen.
Figure 3-20 Technician Screen Access Protected by Password