Ag Leader GeoSteer Operation Manual - Manual (Page 6)

iv GeoSteer System
Verify that you are in a stable position on the vehicle’s
platform or stairs when installing or removing the GeoDock
(the antenna assembly on top of the cab) so you do not fall.
If the vehicle does not provide a safe platform, use a ladder
to safely access the vehicle’s roof.
To avoid electrical shock hazards, remove the GeoDock
and/or other antennas from the vehicle before driving under
low structures or low electrical power lines.
High-Pressure Fluid Hazard
If the installation requires working on the hydraulic system
on the vehicle, read and understand the hydraulic sections
of the vehicle manufacturer’s operators manual before
starting the installation. Wear hand and eye protection while
performing hydraulic system maintenance. Relieve hydraulic
system pressure before servicing the hydraulic system.
If the vehicle has a Wheel Angle Senor as part of the
installation, always shut off the vehicle when working
around the Wheel Angle Sensor while installing, checking,
and adjusting the Wheel Angle Sensor and rod lengths. The
steering mechanism could move suddenly and cause
severe injury or death.