Ag Leader GeoSteer Operation Manual - Manual (Page 119)

OmniSTAR
Operator’s Manual 105
Table 4-1 Expected Initial Startup Accuracies for Different OmniSTAR Modes
Correction Level Fast Startup High Accuracy
OmniSTAR XP 40.0 inches (101.6 cm) 9.0 inches (22.9 cm)
OmniSTAR HP 40.0 inches (101.6 cm) 6.0 inches (15.2 cm)
Note: If Fast Startup is selected, this only affects the accuracy at the initial startup. The accuracy improves to the highest
accuracy enabled by your current subscription in the background as the system continues to run.
Select Startup Accuracy
To set the Startup Accuracy, follow the procedure below:
1. From the GPS screen, press the OmniSTAR button and then select Accuracy from the list on the right.
2. Press the button that matches the startup accuracy required by the user.
Channel
Figure 4-18 OmniSTAR Channel
The Channel screen enables user to choose the appropriate channel for their geographical location. The screen provides the
following information:
• Current Channel – This is the channel the system is currently set to.
• Satellite Name – This is the name of the satellite that is providing the OmniSTAR signal.
• Satellite Frequency – This is the frequency of the signal.
Change Channel
To set the Channel, follow the procedure below: