Ag Leader GeoSteer Operation Manual - Manual (Page 126)

NTRIP
112 GeoSteer System
Add
To add a new profile follow, the procedure below:
Note: Prior to adding a new Profile, NTRIP must be set as the selected RTK Source. Refer to the RTK Connection Type section
on Page 94 for information on how to set this.
1. From the GPS menu, press the NTRIP button.
2. Press the Blue Up/Down buttons or directly select Profile from the list on the right.
3. Press the Add button to add a new profile.
4. Press the Edit button in the Server section.
Figure 4-26 NTRIP Add Profile
5. Type in the name or IP of the server and then press the Green Check button to save the value or the Red X to cancel.
Note: Information type in is case sensitive, be sure to verify the position of the Shift Key to avoid errors.
Note: All the information entered into this screen must be provided by your NTRIP provider. You will need a Server IP,
Port number, Username, and Password to set up a NTRIP Profile. Have this information before attempting to set up the
Profile.