Avaya P330-ML-ML - Manual (Page 76)

Chapter 2 Avaya P330-ML Layer 2 CLI Commands
62 Avaya P330-ML Reference Guide
set cascading
User level: privileged, supervisor.
Use the set cascading command to control the generation of fault-traps for
unconnected cascading links. This command is useful when cascading cables are
not connected intentionally, and therefore no fault-traps are desired for this event.
The syntax for this command is:
set cascading {up|down}fault-monitoring {enable|disable}
Example:
set device-mode
User level: privileged, supervisor.
Use the set device-mode command to select the module’s operating mode —
Layer 2 or Router .
L This command is available on P330-ML-ML and P333R switches only.
The syntax for this command is:
set device-mode
Example:
set dot1x max-req
User level: supervisor
Use the set dot1x max-req command to set maximum number of times the port
tries to retransmit requests to the Authenticated Station before the session is
terminated.
P330-N# set cascading down fault-monitoring enable 1
Module 1 cascading-down fault monitoring enabled
mode • Router – switch operates at Layers 2 and 3.
• Layer2 – switch operates at Layer 2.
Router-N# set device-mode Router
This command will RESET the switch****
Reset **** do you want to continue (Y/N) ?
Done!