Avaya P330-ML-ML - Manual (Page 40)

Chapter 2 Avaya P330-ML Layer 2 CLI Commands
26 Avaya P330-ML Reference Guide
copy startup-config scp
User level: supervisor
Use the copy startup-config scp command to upload the switch-level
startup configuration from the active bank into a file via SCP.
The syntax for this command is:
copy startup-config scp
Example:
copy startup-config tftp
User level: supervisor
L This command applies to the P334T-ML only when it is in “Layer2”
device mode.
Use the copy startup-config tftp command to download a policy
configuration from a TFTP server.
L Only parameters that differ from the factory default settings for the switch are
included in the configuration file. Therefore, it is important to reinitialize the
NVRAM to the factory default settings before downloading configuration files
to the switch. To reinitialize the NVRAM, run the nvram initialize
command.
filename The file name (full path)
ip The IP address of the SCP server
mod-num The switch number
P330-N# copy startup-config scp c:\config\switch1.cfg 192.168.49.10 5
Username: 330user
Password:
Beginning upload operation ...
This operation may take a few minutes...
Please refrain from any other operation during this time.
For more information , use 'show upload status' command
********************************************************************
* If you are currently running the P330-ML Device Manager
application,*
* it is recommended to exit from it before performing configuration*
* download operations. *
********************************************************************