Avaya P330-ML-ML - Manual (Page 123)

Chapter 2 Avaya P330-ML Layer 2 CLI Commands
Avaya P330-ML Reference Guide 109
set queuing scheme
User level: privileged, supervisor.
L This command is applicable to P330-ML-ML switches only.
Use the set queuing scheme command to set the queuing scheme to either strict
or weighted round robin and to set the weights.
The syntax for this command is:
set queuing scheme {wrr {H} | strict | default} [module]
Examples:
set radius authentication enable/disable
User level: privileged, supervisor.
Enables or disables RADIUS authentication for the P330-ML switch.
wrr/strict
/default Sets queuing scheme to weighted round robin, strict, or the default.
H Ratio between high and low priority queues. This parameter is only
used when the queuing scheme is weighted round robin.
module The module number to which the queuing scheme applies. If no
module is specified, the command affects all P330-ML-ML modules
in the stack.
P330-N# set queuing scheme wrr 10 2
Module Queuing Scheme
------ --------------
2 Wrr 10:1
P330-N# set queuing scheme default
Module Queuing Scheme
------ --------------
1 Default
2 Default