Avaya P330-ML-ML - Manual (Page 251)

Chapter 3 Avaya P330-ML Layer 3 CLI Commands
Avaya P330-ML Reference Guide 235
Example:
To set the maximum number of ARP cache entries to 8000:
To restore the maximum number of ARP cache entries to its default:
ip max-route-entries
User level: privileged, supervisor.
L If you are at the ”privileged” level, you can only access this command in
Configure mode.
Type configure at the command prompt to enter configure mode.
The ip max-route-entries command exists for compatibility with Avaya™
P550. There is no limitation on the size of the routing table, except for the amount of
available memory.
Use the no ip max-route-entries command to remove the limitation.
L For this command to take effect, run the copy running-config startup-
config command and reset the device.
The syntax for this command is:
[no] ip max-route-entries
Example:
ip netmask-format
User level: privileged, supervisor.
L If you are at the ”privileged” level, you can only access this command in
Configure mode.
Type configure at the command prompt to enter configure mode.
Use the ip netmask-format command to specify the format of netmasks in the
show
command output.
Use the no ip netmask-format command to restores the default format which is
Router-N(configure)# ip max-arp-entries 8000
Router-N(configure)# no ip max-arp-entries
value Number of entries
Router-N(configure)# ip max-route-entries 4000