Avaya P330-ML-ML - Manual (Page 111)

Chapter 2 Avaya P330-ML Layer 2 CLI Commands
Avaya P330-ML Reference Guide 97
set port powerline
User level: privileged, supervisor.
L This command applies to P333T-PWR switches only and is used by P330-
ML-ML switches to control P333T-PWR modules in the stack.
Use the set port powerinline command to enable or disable the load detection
process and power delivery for the port.
The syntax for this command is:
set port powerinline {[enable] |
disable}
Example:
set port powerline priority
User level: privileged, supervisor.
L This command applies to P333T-PWR switches only and is used by P330-
ML-ML switches to control P333T-PWR modules in the stack.
Use the set port power inline priority command to configure the priority
level of powering the port. Possible values are Critical, High, and Low. At power on
all ports are set to Low Priority.
Within each group, the lowest port number has a highest priority, i.e. within the
ports 1 to 8, port 1 has the highest priority although its priority is lower than port 9
which belongs to High priority group.
The syntax for this command is:
set port powerinline priority
module_
number Number of the module hosting the port for which load detection is to
be enabled/disabled.
port_
number Number of the port for which load detection should be
enabled/disabled.
enable - enables load detection process for port
disable - disables load detection process for port
P330-N# set port powerinline 3/1-3 enable
Load detection process on ports 3/1-3 is enabled
module_number Number of the module hosting the port for which a
powerline priority level is to be set.
port_number Number of the port for which a powerline priority level is
to be set.