Avaya P330-ML-ML - Manual (Page 257)

Chapter 3 Avaya P330-ML Layer 3 CLI Commands
Avaya P330-ML Reference Guide 241
The default is disabled.
The syntax for this command is:
[no] router ospf
Example:
router rip
User level: privileged, supervisor.
L If you are at the ”privileged” level, you can only access this command in
Configure mode.
Type configure at the command prompt to enter interface mode.
Use the router rip command to configure the Routing Information Protocol
(RIP) and enter the “router rip” context.
Use the no router rip command to disable RIP.
The default state is disabled.
The syntax for this command is:
[no] router rip
Example:
To enable the RIP protocol:
router srrp
User level: privileged, supervisor.
L If you are at the ”privileged” level, you can only access this command in
Configure mode.
Type configure at the command prompt to enter configure mode if necessary.
Use the router srrp command to enable srrp redundancy for the main router
and enter the “router srrp” context.
Use the no router srrp command to disble srrp redundancy for the main router.
Router-N(configure)# router ospf
Done!
Router-N(configure router:ospf)#
Router-N(configure)# router rip
Done!
Router-N(configure router:rip)#