Avaya P330-ML-ML - Manual (Page 39)

Chapter 2 Avaya P330-ML Layer 2 CLI Commands
Avaya P330-ML Reference Guide 25
Example:
copy stack-config tftp
User level: supervisor
Use the copy stack-config tftp command to upload the stack-level
parameters from the current NVRAM running configuration into a file via TFTP.
L Create the file into which you wish to upload the stack-level parameters prior to
executing this command.
The syntax for this command is:
copy stack-config tftp
Example:
P330-N# copy stack-config scp c:\config\switch1.cfg 192.168.49.10 5
Username: 330user
Password:
Beginning upload operation ...
This operation may take a few minutes...
Please refrain from any other operation during this time.
For more information , use 'show upload status' command
********************************************************************
* If you are currently running the P330-ML Device Manager
application,*
* it is recommended to exit from it before performing configuration*
* download operations. *
********************************************************************
filename The file name (full path)
ip The IP address of the TFTP server
P330-N# copy stack-config tftp c:\conf.cfg 192.168.49.10
Beginning upload operation ...
This operation may take a few minutes...
Please refrain from any other operation during this time.
For more information , use 'upload status' command
********************************************************************
* If you are currently running the P330-ML Device Manager
application,*
* it is recommended to exit from it before performing configuration*
* download operations. *
********************************************************************