Avaya P330-ML-ML - Manual (Page 131)

Chapter 2 Avaya P330-ML Layer 2 CLI Commands
Avaya P330-ML Reference Guide 117
set spantree default-path-cost
User level: privileged, supervisor.
Use the set spantree default-path-cost command to set the version of the
spanning tree default path costs that are to be used by this bridge.
The syntax for this command is:
set spantree default-path-cost
Example:
set spantree disable
User level: privileged, supervisor.
Use the set spantree disable command to disable the spanning-tree
algorithm for the switch.
L When you disable STP, blocking ports are disabled in order to prevent loops in
the network. As a result, you need to wait 30 seconds before disabling STP if
you reset the switch, enable STP, or insert a new station.
The syntax for this command is:
set spantree disable
Example:
set spantree enable
User level: privileged, supervisor.
Use the set spantree enable command to enable the spanning-tree algorithm
for the switch.
L When you disable STP, blocking ports are disabled in order to prevent loops in
the network. As a result, you need to wait 30 seconds before disabling STP if
you reset the switch, enable STP, or insert a new station.
path-cost common-spanning-tree - compatible with ieee802.1D standard
rapid-spanning-tree - compatible with ieee802.1W standard
P330-N# set spantree default-path-cost rapid-spanning-tree
Spanning tree default path costs is set to rapid spanning
tree.
P330-N# set spantree disable
bridge spanning tree disabled.