Avaya P330-ML-ML - Manual (Page 130)

Chapter 2 Avaya P330-ML Layer 2 CLI Commands
116 Avaya P330-ML Reference Guide
Example:
To enable SNMP ConfigChange traps to a specific manager:
Example:
To enable all traps to a specific manager:
Example:
To disable SNMP config traps to a specific manager:
Example:
To add an entry in the SNMP trap receiver table with default:
set snmp trap auth
User level: privileged, supervisor.
Use the set snmp trap auth command to enables or disable the sending of
SNMP traps upon SNMP authentication failure.
The syntax for this command is:
set snmp trap {enable|disable} auth
Example:
P330-N# set snmp trap 192.168.173.42 enable config
SNMP config change traps enabled.
P330-N# set snmp trap 192.168.173.42 enable all
SNMP all traps enabled.
P330-N# set snmp trap 192.168.173.42 disable config
SNMP config traps disabled.
P330-N# set snmp trap 192.168.173.42
SNMP trap receiver added.
P330-N# set snmp trap enable auth
Authentication trap enabled