Avaya P330-ML-ML - Manual (Page 260)

Chapter 3 Avaya P330-ML Layer 3 CLI Commands
244 Avaya P330-ML Reference Guide
set policy type
User level: privileged, supervisor.
L This command is available on the P334T-ML switch in device mode “Router”
only.
Use the set policy type command to set whether the P334T-ML module
enforces the active policy-list on all packets or only on routed packets (for modules
in 'device-mode router').
The syntax for this command is:
set policy type all | router
Example:
set qos policy-source
User level: privileged, supervisor.
L If you are at the ”privileged” level, you can only access this command in
Configure mode.
Type configure at the command prompt to enter Configure mode if
necessary.
Use the set qos policy-source command to set the policy source (local or
policy server).
The syntax for this command is:
set policy source
value all - apply policy to all packets entering the
P334T-ML through Fast Ethernet ports
router - apply policy on routed packets only
Router-N# set policy type all
source local or policy server
• The default policy source for P330-ML-ML switches is local
• The default policy source for P333R and P333R-LB switches
is policy-server