Avaya P330-ML-ML - Manual (Page 258)

Chapter 3 Avaya P330-ML Layer 3 CLI Commands
242 Avaya P330-ML Reference Guide
Example:
To enable the srrp:
router vrrp
User level: privileged, supervisor.
L If you are at the ”privileged” level, you can only access this command in
Configure mode.
Type configure at the command prompt to enter configure mode if necessary.
Use the router vrrp command to enable VRRP router redundancy globally.
Use the no router vrrp command to disable VRRP router redundancy.
The syntax for this command is:
[no] router vrrp
Example:
session
User level: user, privileged, supervisor
Use the session command to open a session with a specific entity in a switch of
the stack. For example, you can open a session with the Routing entity of a
P332G-ML switch in the stack.
The syntax for this command is:
session [ [switch|router|atm|mgp|wan]]
Router-N(configure)# router srrp
Done!
Router-N(configure router:srrp)#
Router-N(configure)# router vrrp
Done!
mod_num (optional) The switch number.
If you do not specify this parameter, you will
get the default entity of the stack (Layer 2
session to the Master)