Avaya P330-ML-ML - Manual (Page 312)

Chapter 3 Avaya P330-ML Layer 3 CLI Commands
296 Avaya P330-ML Reference Guide
Router SRRP Context
L You can only access these commands in the “Router-SRRP” context.
Type router srrp at the command prompt to enter the “Router -SRRP”
context if necessary.
poll-interval
User level: user, privileged, supervisor
Use the
poll-interval command to configure the polling interval in seconds
used by SRRP.
Use the
no poll-interval command to return to the default polling interval of
1 second.
The syntax for this command is:Syntax
[no] poll-interval
Example:
timeout
User level: user, privileged, supervisor
Use the
timeout command to configure the timeout (in seconds) after which
SRRP declares the main router dead if it does not reply to polling.
Use the
no timeout form command to return the timeout to default timeout
interval of 12 seconds.
The syntax for this command is:
[no] timeout
Example:
L The timeout should be at least twice as long as the interval.
poll interval Poll interval (integer value, in seconds)
Router-N# poll-interval 4
timeout An integer (in seconds)
Router-N# timeout 6