Avaya P330-ML-ML - Manual (Page 58)

Chapter 2 Avaya P330-ML Layer 2 CLI Commands
44 Avaya P330-ML Reference Guide
ip telnet-client enable
User level: supervisor
Use the ip telnet-client enable command to enable the device to act as a
Telnet client.
L This command can only be run from the console port on the device.
The syntax for this command is:
ip telnet-client enable
Example:
no ip http
User level: supervisor
Use the no ip http command to disable HTTP access to the device.
The syntax for this command is:
no ip http
Example:
no ip icmp redirect
User level: supervisor
Use the no ip icmp redirect command to disable ICMP redirects via the
device.
The syntax for this command is:
no ip icmp redirect
Example:
P330-N# ip telnet-client enable
Done!
P330-N# no ip http
Done!
P330-N# no ip icmp redirect
Done!