Ping, Prompt-length, Ping prompt-length – Avaya P330-ML-ML User Manual
Page 255
Chapter 3 Avaya P330-ML Layer 3 CLI Commands
Avaya P330-ML Reference Guide
239
Example:
ping
User level: user, privileged, supervisor
Use the ping command to send ICMP echo request packets to another node on the
network.
L You can use this command via the master switch only.
L The command is executed until you
The syntax for this command is:
ping address>]]]]] Example: to ping the IP number 149.49.48.1 three times: prompt-length Router-N(configure)# ip simulate 100 192.67.85.12 193.76.54.25 host Host IP address/Internet address of route destination. If missing interval Interval between ping commands in seconds (1 to 256) size Size of packet in bytes (22 to 66500) timeout Timeout in seconds (1 to 10) source IP address of one of the router interfaces Router-N> ping 149.49.48.1 3 PING 149.49.48.1: 56 data bytes 64 bytes from 149.49.48.1: icmp_seq=0. time=0. ms 64 bytes from 149.49.48.1: icmp_seq=1. time=0. ms 64 bytes from 149.49.48.1: icmp_seq=2. time=0. ms ----149.49.48.1 PING Statistics---- 3 packets transmitted, 3 packets received, 0% packet loss round-trip (ms) min/avg/max = 0/0/0
then the last host IP is used.
address