Avaya P330-ML-ML - Manual (Page 310)

Chapter 3 Avaya P330-ML Layer 3 CLI Commands
294 Avaya P330-ML Reference Guide
Example:
passive-interface
User level: privileged, supervisor.
Use the passive interface command to allow interfaces to be flooded into the
OSPF domain as OSPF routes and not external routes.
L An interface becomes passive only if you use the network command to enable
OSPF to run on the interface.
The syntax for this command is:
passive-interface
Example:
redistribute
User level: privileged, supervisor.
Use the redistribute command to redistribute routing information from other
protocols into OSPF.
Use the no redistribute command disables redistribution by OSPF.
The syntax for this command is:
[no] redistribute
area id Area ID. This parameter exists for compatibility with
P550.
Router-N(configure router:ospf)# network 192.168.0.0
Router-N(configure router:ospf)# area 192.168.0.0
0.0.255.255 area 0.0.0.0
interface-name /
net addr Name of interface or IP address.
Router-N# passive-interface FastEthernet 1.10
protocol • static
• conneted
• RIP