Avaya P330-ML-ML - Manual (Page 116)

Chapter 2 Avaya P330-ML Layer 2 CLI Commands
102 Avaya P330-ML Reference Guide
The syntax for this command is:
set port spantree force-protocol-migration
Example:
set port spantree priority
User level: privileged, supervisor.
Use the set port spantree command to set the Spanning Tree priority level of a
port. This value defines the priority of a port to be blocked in case two ports with
the same costs cause a loop.
The syntax for this command is:
set port spantree priority [module/port] [value]
Example:
L Priority value 0 will set the port to Root port.
set port speed
User level: privileged, supervisor.
Use the set port speed command to configure the speed of a port or range of
10/100BASE-T ports.
In auto-negotiation mode, the port's speed is determined by auto negotiation. An
error message is generated if you attempt to set the speed when auto negotiation is
enabled
module/
port Port identifier
P330-N>set port spantree force-protocol-migration 1/1
port 1/1 is forced to send a Rapid spanning tree BPDU
module/port Module number/port number.
value Number representing the priority of the bridge. The
priority level is from 0 to 240, with 0 indicating high
priority and 240 indicating low priority. Value should be
in steps of 16; default value is 128.
P330-N# set port spantree priority 3/4 128
port 3/4 spantree priority is 128